Crown 3-5/8"

This decorative 3-5/8" crown mould measures 3.625" wide by .750" thickness, allowing the pattern to be milled sprung (laying horizontally flat) out of four-quarter lumber. The beautiful terminating profile is composed of a 35/64" radius convex arc on the bottom, (if the crown were installed upside down, it them would become a supporting profile), attached to an 11/64" vertical fillet merged with a 2-5/8" radius cove and a 9/32" wide horizontal line segment on the bottom right side of the design. The spring angles are fixed at forty-five degrees, these explicit back bevels keep the inner profile parallel to the wall and ceiling as well as set the installed height at 2-5/8" tall with a projection of 2-1/2" wide.