Panel Moulding 2-1/4" - 15

This wonderful panel molding 2-1/4" - 15 measures 2.250" wide by .750" thickness, enabling a 2-1/2" wide blank of four-quarter lumber for milling on an industrial molder. The stylish profile contains a 41/64" wide by 11/64" tall raised fillet with 3/16" rounded corners on the top left. The inner round-over connects to a 1/8" sunk fillet in the center, merged with a 1-5/32" flat line with 3/16" rolled edges and a two tangent radius ogee on the design's right side. The rabbet dimension is 1/4" wide by 3/8" tall.

Ever notice why some moldings look better than other trim patterns in homes, offices, and older buildings. You may want to review our article on knife marks per inch. Read about how machine feed rates and rpm of cutter heads can directly determine the quality of the products you produce. Following or exceeding industry standards will allow your company to lead the way in molding artisanship.

For knife quoting purposes, click to open the calculator below; we supplied only the important measurements, enter the appropriate dimension in the boxes provided. A brief detailed explanation on how to use the calculator is located here. If you would like some assistance with the dimensions, print a copy of our fraction - decimal - millimeter chart, place it on the molder or around the shop to help machine operators save time and increase accuracy during setup procedures.

Width = 2.250" / Depth of Cut = .401" (top knives).

Thickness = .750" / Depth of Cut = .250" (left cutters).