Crown 2-1/2" - 20

This petite 2-1/2" - 20 colonial crown mould measures 2.500" wide by .750" thickness, allowing the detail to be milled from four-quarter lumber. The traditional profile comprises a two-tangent radius cyma recta in the center flanked by small vertical line segments above and below, attached to a 25/64" cove with a 9/32" horizontal line at the bottom of the pattern. The spring angles are fixed at thirty-eight and fifty-two degrees, these specific back bevels set the installed height at 1-15/16" tall with a projection of 1-37/64" wide.

Read our commentary about axial constant positioning for crown bevels, the article will help you dial this profile in axially on the first try when milling this detail provided the machine is axially calibrated. Three high points in the detail were intentionally positioned on the same plane; our disciplined design features will assure excellent hold-down conditions while milling, providing the machines pressure shoe is parallel to the bed plates.