Crown Moulding 6-3/8" - 2

This elegant crown molding 6-3/8" - 2, measures 6.375" wide by .812" thickness, permitting the use of four quarter lumber for milling on an industrial-grade molder. The well-balanced terminating profile contains a 1/2" vertical line segment joined to a 13/32" cove with a 5/16" by 5/16" perpendicular notch on the top left. This area merges with a graceful two tangent radius cyma recta in the center, connected to a 5/8" tall line with a 3/8" cove and a 15/64" broad horizontal line at the bottom right side of the design. The set spring angles are at forty-five degrees; these dedicated back bevels keep the face side of the profile parallel to the wall and ceiling when installed, they also lock in the positioned height at 4-41/64" tall with a projection of 4-3/8" across the top.

Ever notice why some moldings look and feel better than other trim patterns in homes, offices, and older buildings. You may want to review our article on knife marks per inch. Read about how machine feed rates, rpm's of cutter heads can directly determine the quality of the products you produce. Following or exceeding industry standards will allow your company to lead the way in molding artisanship.

For molding knife quoting purposes click to open the calculator below, we supplied only the important measurements, enter the appropriate dimension in the boxes provided. A brief detailed explanation on how to use the calculator is located here. If you would like some assistance with the dimensions print a copy of our fraction - decimal - millimeter chart, place it on the molder, or around the shop to help machine operators save time and increase accuracy during setup procedures.

Width = 6.375" / Depth of Cut = .426" (top knives).

Thickness = .812" / Depth of Cut = .473" (right blades) & .661" (left cutters).