WM 58 Crown 2-3/4" - 7

This 2-3/4" - 7 WM 58 crown mould measures 2.750" in width by .562" in thickness. The graceful terminating profile comprises a two-tangent radius cyma recta in the center, joined to an 11/16" tall line on the top left. The lower portion contains 29/64" tall by 7/16" wide perpendicular lines at the design's bottom right corner. The spring angles are fixed at thirty-eight and fifty-two degrees; these specific back bevel cuts set the installed height at 2-7/32" tall with a projection of 1-5/8" across the top. The recommended rough wood rip size for milling sprung (laying horizontally flat) using four-quarter lumber is 3" wide.

Review our commentary about axial constant positioning for crown bevels. The article will help you dial this profile in axially, provided the machine is adequately calibrated . Three high points in the pattern layout are deliberately positioned on the same plane. Our disciplined design features will assure excellent hold-down conditions while milling as long as the pressure shoe is parallel to the machine bed-plates.

The current combined high-speed knife steel & template prices are listed below for quoting purposes. On itemized costs, you may only need knives for a specific part of the detail, saving money using cutters you already own. On most of our crown designs, we utilize a full 2.375"/60mm cutter head for the back bevel angles to allow for multiple axial adjustments on a wide range of profiles.